Bus passenger flow statistics is to accurately count the real-time passenger flow in and out of each vehicle by installing passenger flow statistics equipment on the bus, so that the bus company can scientifically manage and dispatch bus vehicles based on passenger data.
The intelligent management equipment of the bus passenger flow statistics system independently developed and produced by Shenzhen Cardlan Technology Co., Ltd. can provide decision guidance for the bus company's vehicle operation management, and also ensure the safety of passengers taking the bus. This article introduces in detail how to install bus passenger flow statistics equipment and the matters needing attention during installation.
Installation method of passenger flow statistics equipment
The method of counting passenger flow is not the same, so generally speaking, the commercial passenger flow statistics device can be installed on the ceiling above the door, and the passenger flow statistics device can be close to the ceiling (generally the ceiling is parallel to the ground and perpendicular to the pedestrian) of). It is generally required not to expose the line when installing, it can be more beautiful.
Bus passenger flow statistics equipment, due to the particularity of the car itself, the top of the car is a slope, most of the existing urban buses have been installed such as GPS system, DVR monitoring system, car entertainment system, etc., our passenger flow statistics system considers these and Data transmission and docking of each system. Interface design RS485, RS232, USB2.0 mode.
The door is generally only two meters high. In order to make the video range of the camera wide enough, it is generally not installed directly above the door. It is best to tilt the device slightly, and the installation height is about 2.5 meters. When the wiring causes insufficient power or voltage, it will cause the acquired image The quality is not good, the equipment is unstable, the equipment cannot be started, etc., so the drop-off line is a little bit outside the door, so that a better counting effect can be achieved.